Comments
-
i feel your pain with Gen7 but i haven't seen this happen with our devices yet, try temporarily setting the log level to debug when you're actively monitoring ( make sure to set it back to previous setting when you're done, its a lot of overhead logging and fills the buffers up real quick ( also do an export of current…
-
i ment *internal yaml for sonicos*
-
follow up: apparently its the internet site yaml file
-
literally a minute after i tried again, its how sort of showing online... i'm putting a monitor on the page so i can see the stability over 48 hours , let me know how it goes on your side
-
kind of online, but not really... its failing to load the sonicos_openapi yaml file
-
whats your case number you refer to if i may ask, ours is with engineering at the moment: case number: 44029548 and 44031908
-
make sure to enable removal of default rules in the diag page and then remove the broken rules and then disable removal of default rules in the diag page again :)
-
they will get somewhere some day! slowly but surely
-
we had this exact issue! below fixed it! Description In some cases, not able to access High availability idle device using monitoring IP address. This article describes adding necessary rules to get access to the standby/idle unit using it's monitoring IP Resolution Resolution/Workaround: Need to create below NAT policies…
-
Hi Micah, Thanks for the response but what does shortly mean in terms of ETA ? a couple hours? / days ?
-
you can either use a file format detection tool like tridnet to figure out what file format it is or just get sonicwall support to look at it
-
send the unit back as thats a hardware fault
-
what happens is you just use tar zxvf or gunzip
-
Hi All, i've posted on reddit as wel, we've upgraded some of our gen7 devices from 5065 to 5080, so far there's been 1 issue which we have now seen on : 1 X TZ670 HA STATEFULL Pair 1 X TZ370 To Give a Description Basically the issue we have seen: autogenerated ACL's from VPN policies , where in the ACL the subnet was…
-
just going to bump this as i'm running into the same issue with oracle version 19c i'm adding the original pdf from oracle here to maybe help some people but what i'm running into is that we have this software thats controller by third party and they cannot change the settings on the framework hence we are still running…